Biomechanical behavior of carbon fiber-reinforced polyetheretherketone as a dental implant material in implant-supported overdenture under mandibular trauma: A finite element analysis study.

Context: Implant-supported overdentures are well-known and widely accepted treatment modality to increase retention which is a crucial factor for determining patient satisfaction. The placement of two implants in the anterior region can be selected as a first-line treatment in patients with the atrophic mandibular ridge. Aims: The purpose of this research was to assess the biomechanical effects of carbon fiber-reinforced polyetheretherketone (CFR-PEEK) implant-supported overdenture in the event of 2,000 N forefront trauma to an atrophic edentulous mandible by using the finite element analysis method. Materials and Methods: Three types of mandible models were simulated; the first one was an edentulous atrophic mandible model; in the second model, 3.5 × 11.5 mm CFR-PEEK implants; and in the third model, 4.3 × 11.5 mm CFR-PEEK implants were positioned in the region of the lateral incisor of the identical edentulous atrophic mandible. Results: Maximum Von Misses stresses 979.261 MPa, 1,454.69 MPa, and 1,940.71 MPa and maximum principal stresses 1,112.74 MPa, 1,249.88 MPa, and 1,251.33 MPa have been detected at the condylar neck area and minimum principal stresses - 1,203.38 MPa, -1,503.21 MPa, and - 1,990.34 MPa have been recorded at the symphysis and corpus regions from M1 to M3, respectively. In addition, the M2 and M3 models showed low-stress distributions around the implant-bone interface, particularly where the implants were in contact with cancellous bone. Conclusions: The results showed that the insertion of different diameters of CFR-PEEK implants led to low and homogenous stress distribution all around the implant-bone interface and stresses transferred directly to the condylar neck areas. Therefore, it was observed that CRF-PEEK implants did not change the basic behavior of the mandibula in response to frontal stresses.

Evaluation of the effects of platelet-rich fibrin and piezosurgery on outcomes after removal of impacted mandibular third molars.

We compared postoperative outcomes after the removal of 80 impacted mandibular third molars in 59 patients. In the control group, osteotomies were done with traditional burs (n=20). The second group had traditional osteotomies and platelet-rich fibrin (PRF) placed into the socket of the extracted tooth (n=20). The third group had piezosurgery (n=20), and the fourth had piezosurgery and PRF placed in the extraction socket (n=20). Baseline variables were assessed preoperatively and included pain, the number of analgesics taken, trismus, and swelling. These were also assessed on postoperative days 1, 2, 3, and 7. There was a significant reduction (p<0.05) in pain on days 1, 2, and 3, and in the number of analgesics taken on days 2 and 3 in both PRF groups. However, in the piezosurgery alone group this was the case only on day 3. There was no significant difference in swelling and trismus between the control and other groups.